Kurzweil Forte 7 - Parameter Assignments; Controller Conventions

Multi Mode
Parameter Assignments
8-8
Parameter Assignments
In Multi Mode, each Multi has factory-set Program and Eect parameters assigned to
physical controllers (Sliders, Switch buttons, Mod Wheel, and Pedals). A parameter
assignment can modify an instrument sound during a performance to add variation or
expression. Moving a controller changes the value of the parameter. Any time you do this,
the display shows the Controller name, assigned parameter, and value.
NOTE : Parameter assignments may not be visible if the VIEW soft
button has been pressed, or the “Display” parameter in Global Mode
has been changed.
Controller Conventions
In Multi Mode, the Zone Mute Switches above Sliders A through D control the Active/Muted
status of Zones 1 through 4. In the Factory Multis, Sliders A through D generally control the
volume for Zones 1 through 4. Sliders H and I generally control Delay and Reverb amount.
e remaining Sliders and Switches generally control various eects and synthesis parameters.