Multi Edit Mode
Selecting Parameters
9-4
Alpha Wheel & Previous (–) and Next (+) Value Buttons
Use the Alpha Wheel or the Value buttons, to the right of the display below the Alpha
Wheel, to change the selected parameter value. Turning the Alpha Wheel counter-clockwise
or pressing the Previous button will select the previous value and turning the Alpha Wheel
clockwise or pressing the Next button will select the next value.
Assign
Assign is the secondary function of the Enter button. You can use the Assign function to
quickly select parameters or set values for parameters by holding the Enter button while
moving Forte controllers (Sliders, Switch buttons, Keys, Mod Wheel, and Pedals).
Parameters that can use the Assign function are indicated by showing the Assign symbol in
the top right corner of the display when selected.
Pressing a key, switch, or moving a controller while holding down the Enter button will
perform Assign in the following cases.
To Next Page
Loading...
