Kurzweil Forte 7 - Output; Auxiliary Send Parameters

Program Edit Mode
Program Pages
7-9
Output
e Output parameter species the rear panel analog output pair to which the selected aux
bus is routed. Setting the Output to A routes the signal of the selected bus to output pair A.
Setting the Output to B routes the signal of the selected bus to output pair B. is is useful
if you want to control the processed Aux signal with an external mixer or process the signal
with additional external eects.
Auxiliary Send Parameters
e Auxiliary Send parameters determine the level of the program signal sent to the auxiliary
eects chain.
Aux Send
e Aux 1 send works as a dry/wet mix, so that as you turn up the Aux 1 send,
the program’s unprocessed signal is turned down. With an Aux 1 send set to 50%
you hear an equal amount of processed and unprocessed signal (called wet and dry,
respectively.) With an Aux send set to 100% you hear only the processed (wet) signal
and none of the original unprocessed (dry) signal.
For most programs, the Aux 2 send works the same way as the Aux 1 send, and
send level is set in percent. For some programs (mostly piano programs), the Aux
2 send level is set in dB and works more like a traditional send on an audio mixing
board. e level of signal sent to the Chain is set in dB, the higher the value the
more processed signal you will hear. When the Aux 2 send level is set in dB, the
unprocessed signal does not get turned down as the Aux 2 send is turned up.
Pre/Post Ins
e Pre/Post Insert parameter determines the point at which the auxiliary eect is
applied to the signal.
When this parameter is set to Post, the Forte applies the auxiliary eect to the signal
post insert, i.e., after the insert eect has been applied.
When this parameter is set to Pre, the Forte applies the auxiliary eect to the signal
pre insert.
To hear a program put through two eects Chains in series (i.e., route the processed
Insert signal through the Aux 1 Chain), choose your desired eects Chains for the
Insert and Aux 1, set each bus Output to Main, and set the Aux 1 Send parameter to
100%. en, set the Pre/Post Insert parameter to Post.
To hear a program put through two eects Chains in parallel (i.e., don’t route the
processed Insert signal through the Aux 1 Chain), choose your desired eects Chain
for the Insert and either Aux, set each bus Output to Main, and set the Aux Send
parameter to either 50% or 0 dB. en, set the Pre/Post Insert parameter to Pre for
the desired aux.