Kurzweil Forte 7 - Aux FX Channel; Aux1, Aux2; AUX1 Override, AUX2 Override; Chain

Multi Edit Mode
FX Page
9-28
Aux FX Channel
e Aux FX Channel determines the FX channel through which the aux sends of all of
the zones in the current Multi are sent. For example, if a zone 2 in a Multi has a program
with 25 Basic Delay 1/8 as an Aux FX, and zone 2 is assigned to channel 5, then setting the
Aux FX Channel to 5 sends the programs of all of the zones in the Multi through zone 2’s
Program’s Aux FX (i.e., through 25 Basic Delay 1/8).
AUX1, AUX2
e setting for the AUX1 (Auxiliary 1) & AUX2 (Auxiliary 2) parameters determines if the
auxiliary send level for the selected Zone program is overridden, and if so, by what value. e
two Auxiliary eects busses are global to all zones/channels on the Forte. e default value of
[p] means “no override” (i.e., use the values specied in the program.) To override the send
level value, select the AUX1 or AUX 2 send level parameter for the desired Zone, and enter
a new value with the Alpha Wheel, -/+ buttons, or enter a value with alphanumeric pad and
press the Enter button.
AUX1 Override, AUX2 Override
Normally, the Aux Eects Chains are specied by the program on the specied Aux Eects
channel. When Override is set to Yes, the Chain parameter can be selected, allowing you to
choose a dierent Aux eect Chain.
Set Override to Yes to select an override Aux Chain on this page. Set Override to No to use
the Aux FX chain of the specied Aux FX Channel.
Chain
When AUX1 Override or AUX2 Override is set to Yes, you can select an override Aux Chain
for the corresponding Aux Eect. e Chain parameter can not be selected when Override is
set to No, and “(Prog)” is shown as a reminder that the Chain from the Program on the Aux
FX Channel is being used. (See Appendix F Eects on page F-1 for a full list of available
Eect Chains).