Kurzweil Forte 7 - Assign Functionality for Controller Mapping

Program Edit Mode
Selecting Parameters
7-3
Assign
Assign is the secondary function of the Enter button. You can use the Assign function to
quickly select parameters or set values for parameters by holding the Enter button while
moving Forte controllers (Sliders, Switch buttons, Keys, Mod Wheel, and Pedals).
Parameters that can use the Assign function are indicated by showing the Assign symbol in
the top right corner of the display when selected.
Assign symbol
Pressing a key, switch, or moving a controller while holding down the Enter button will
perform Assign in the following cases.
Enter + Controller
On the Program Edit Mode Parameters page, select any parameter in the Parameter column,
hold the Enter button and move a controller (a Slider, Switch button, Mod Wheel or Pedal).
Doing this will jump to selecting the parameter that is assigned to the moved controller (if a
parameter is assigned to that controller).
On the Program Edit Mode Parameters page, select any parameter in the Control column,
hold the Enter button and move a controller (a Slider, Switch button, Mod Wheel or Pedal).
Doing this will assign the selected parameter to be controlled by the moved controller.