Kurzweil Forte 7 - Program Pages: PARAMS, FX, COMMON

Program Edit Mode
Program Pages
7-4
Program Pages
e parameters for each page in Program Edit Mode are explained in detail below.
PARAMS Page
Parameter Range Of Values Default Value
Parameter Program / Effect Chain dependent -
Control Physical controller or MIDI CC None
Value None, 0 to 127 None
Press the PARAMS soft button to display the Parameters page (see above.)
e Parameters page allows you to access all of the controllable parameters for the current
program. e parameters page will also display any available VAST synthesis parameters
for the current program and parameters for the current program’s insert and auxiliary 1&2
eects (if eects are in use.) All available parameters are listed. For each parameter you can
set a MIDI value as well as a control source.
e left column lists the available parameters, the center column shows the control source
(either a physical controller or MIDI CC number) which that parameter is controlled by, and
the right column shows the MIDI value for each parameter.