Kurzweil Forte 7 - Destination; Controlling Program Parameter Assignments from Multi Mode

Multi Edit Mode
CONTROLS Page
9-24
Destination
Use the Destination parameter to assign the Forte physical controllers (Sliders, Pedals,
Switches, Mod Wheel, etc.) to control Program parameters or send MIDI continuous
controller messages (CCs) to external MIDI gear. If a CC number is assigned to a parameter
in the Program of the current Zone, the parameter name will be listed in the Destination list
in place of that CC number.
e Destination parameter determines the MIDI CC controller number that a physical
controller will send to the Program in the currently selected Zone. By default, these CC
messages are also sent to the MIDI Out and USB ports on the Channel of that Zone.
e list of CC controller numbers below shows the default assignments for each destination.
Programs respond to some of these CCs for standard MIDI functions like volume and
panning. Other external MIDI gear (sound modules, computer software) may respond to
standard MIDI CC messages as well.
Controlling Program Parameter Assignments from Multi
Mode
Commonly you will want to assign a physical controller in a Multi to control the same
Program parameter that it controlled in Program Mode. In the Destination parameter list,
destinations that are assigned to parameters for the Program of the current Zone will show
the Program Parameter name in place of the standard Controller Destination name. Select
one of these destinations to control an assigned Program parameter.
The Contoller Destination List
e table below contains the available values for the MIDI CC (continuous controller)
destinations. e Forte’s physical controllers can send MIDI values to these destinations
in order to control the parameters of Forte Programs, Multis, Forte system parameters, or
external MIDI equipment.
Controller
Number
Controller
Destination
Description
0 OFF/Bank
By default, when you enter 0 or Clear for the Destination parameter, the destination
will be assigned to OFF. To select Bank as the destination, use the Value buttons.
1 MWheel
Default destination for the Modulation Wheel
2 Breath
Default assignment for breath controller in compatible synths
3 MIDI 03
MIDI Controller 3
4 Foot
Default assignment for continuous foot controller in compatible synths
5 PortTim
Monophonic Forte Programs respond to this Controller if portamento is turned on.
6 Data
MIDI Controller 6
7 Volume
MIDI Volume
8 Balance
MIDI Balance
9 MIDI 09
MIDI Controller 9
10 Pan
MIDI Pan