Multi Edit Mode
Arpeggiator, CC Seq and Riff Page
5-14
Edit Arpeggiator Settings
To edit the Arpeggiator settings, select the Arpeggiator parameter for the desired Zone, set
the parameter to On, then press the EDIT button to view the Arpeggiator page.
e Arpeggiator in Multi Mode is very similar to the Program Mode arpeggiator. See
Arpeggiator Page on page 3-12 of the Program Edit Mode Chapter for a full description of
each arpeggiator parameter.
In Multi Mode, the Arpeggiator works the same as in Program Mode, except there is one
arpeggiator per Zone. e Arpeggiator in each Zone can each have dierent settings, and
they can be played at the same time. Also, in Multi Mode the Arpeggiator page does not have
the Tempo parameter, instead the Tempo parameter on the Multi Common page should be
used.
Unlike the Arpeggiator in Program Mode, the Arpeggiator in Multi Mode has the Sync
Type parameter. Setting the Sync Type parameter to Any Beat will keep arpeggiators in sync
to the same beat pulse across multiple Zones. When the Sync Type parameter is set to Any
Beat, playing an arpeggiator in one Zone will wait for the next beat of any currently playing
arpeggiators before starting. Set the Sync Type parameter to O if you don’t want to keep
arpeggiators in sync. Additional Sync Type settings are available, which behave the same as
the Ri Sync Types. See Trigger Type on page 5-20 for details.
To assign the ARP and LATCH button for the arpeggiator in each Zone, go to the Controls
page and set the Controller eld to ArpOn/O or ArpLatch for each desired Zone. See
“Switch Controllers” on page 7-13 for details.
To Next Page
Loading...
