Kurzweil PC4 SE - Page 103

Multi Edit Mode
Arpeggiator, CC Seq and Riff Page
5-15
CC Sequencer
e CC Sequencer parameters set whether the CC Sequencer is On or O for the Program
in each Zone.
CC Sequencer On/O can also be controlled in each Zone by the front panel CC SEQ
button. In each Multi, the CC SEQ button must be assigned for the desired Zones on the
Multi Edit Controls page. Set Controller to CC Seq, then select Destination 148 (CC Seq
On/O) with On Value 127 and O Value 0.
CC Sequencer On/O can also be controlled with other controllers on the Multi Edit
Controls page by using Destination 148 (CC Seq On/O).
Edit CC Sequencer Settings
To edit the CC Sequencer settings, select the CC Sequencer parameter for the desired Zone,
set the parameter to On, then press the EDIT button to view the CC Sequencer page.
e CC Sequencer in Multi Mode is very similar to the Program Mode CC Sequencer. See
MIDI CC Step Sequencer Page on page 3-27 of the Program Edit Mode Chapter for a full
description of each CC Sequencer parameter.
In Multi Mode, the CC Sequencer works the same as in Program Mode, except there is one
CC Sequencer per Zone. e CC Sequencer in each Zone can each have dierent settings,
and they can be played at the same time.