Kurzweil PC4 SE - Page 104

Multi Edit Mode
Arpeggiator, CC Seq and Riff Page
5-16
Riff
e Ri parameters set whether the Ri is On or O for the Program in each Zone.
Ris are full songs or individual tracks of a song created in the PC4 SE’s Song mode
that you can trigger in Multi mode. Standard MIDI les may also be imported to Song
mode and then used as ris in Multis. Every zone in a Multi can have it’s own ri—a
completely independent sequence. You can use a Multi with many ris to trigger and stop
looped sequences of dierent instrument parts. Alternatively, a single ri can play multiple
instrument parts, and each ri can be used as a dierent song section of a backing track.
Edit Riff Settings
To edit the Ri settings, select the Ri parameter for the desired Zone, set the parameter to
On, then press the EDIT button to view the Ri page.
Follow these steps to use a ri:
1. Go to Song mode and nd or record the song that you wish to use for your ri. Note the
song ID#, as well as the desired track and start/stop points.
2. Go to Multi mode and edit a Multi. On the Multi Edit Overview page, choose the
program that you want to use for the ri on the desired zone. (Program changes that are
recorded in song mode will be ignored when using the song as a ri in a Multi.)
3. Go to the Arpeggiator, CC Sequencer and Ri Page page, set the Ri parameter to On
for the desired Zone, and press the EDIT button to got to the Ri page.
4. On the Ri page, select the desired song, track, song Start/Stop points. See below for
descriptions of these parameters, as well as many other parameters that determine the
behavior of a ri.
Note: By default, setting a zone to trigger a ri will disable the ability to play notes of that
Zone’s program from the keyboard. To re-enable this ability, see “Local” on page 5-19.