Multi Edit Mode
Controls Page
5-30
If the Global Mode “Multi Controllers” parameter is set to Pass Entry, and the physical
controller is above or below the Entry value when the Multi is selected, moving the controller
will have no eect until it is moved past the Entry value.
Exit
e Exit parameter determines the value of a continuous controller when the current Multi is
exited by selecting another Multi or Program. You can set this parameter to None, or 0-127.
is parameter aects the selected continuous controller for all Zones.
Exit should typically be set to a value of “None”, which sends no message. To select a value
of None, scroll below 0. Setting an Exit Value to 0-127 can be useful for advanced MIDI
congurations and when controlling external MIDI instruments or software.
To Next Page
Loading...
