Kurzweil PC4 SE - Page 117

Multi Edit Mode
Controls Page
5-29
When Scale is set to 50%, the controller sends CC values 0-63, 0 at its lowest position, and
63 at its highest position. With the Add parameter set to 64, the controller sends CC values
64-127, 64 at its lowest position, and 127 at its highest position.
When Scale is set to 200%, the controller sends CC values 0-127, 0 at its lowest position,
and 127 at its middle position through its highest position. With the Add parameter set to
64, the controller sends CC values 64-127, 64 at its lowest position, and 127 at its middle
position through its highest position.
Curve
e Curve parameter lets you apply dierent curves to the controller values, in order to make
the controller more or less responsive in certain ranges of controller positions, or to distribute
high and low values over dierent ranges of controller positions.
e Linear setting distributes CC values 0-127 evenly over the range of the controller, with
0 at its lowest position, and 127 at its highest position. is is the default setting.
e Compress settings distributes more of CC values 0-127 over the bottom half of the
controller range, and fewer CC values over the top half of the controller range.
e Expand setting distributes more CC values 0-127 over the top half of the controller
range, and fewer CC values over the bottom half of the controller range.
e Crossfade setting is designed to be used in combination with the Rvrs Crossfade setting,
in order to smoothly crossfade between two programs on dierent Zones. Assign the Same
controller to Destination 7 on two Zones, and select one of these curves for the controller on
each Zone.
e Bump setting distributes CC values 0-127 to resemble a bell curve, with 0 at its lowest
and highest positions, and 127 at its middle position
e Reverse settings (Rvrs Linear, Rvrs Expand, Rvrs Compress, and Rvrs Crossfade)
distribute values in the reverse compared to the regular version of these settings. For
example,the Rvrs Linear setting distributes CC values 0-127 evenly over the range of the
controller, with 0 at its highest position, and 127 at its lowest position. .
Entry
e Entry parameter determines the value of a continuous controller when the current Multi
is loaded. You can set this parameter to None, or 0-127.
is parameter aects the selected continuous controller for all Zones. e Scale, Add and
curve parameters are applied to the Entry value individually on each zone, allowing one
controller to send dierent values to dierent zones, if desired.
If Entry is set to None, then when you load the current Multi, the continuous controller
value will not change.