Kurzweil PC4 SE - Page 120

Multi Edit Mode
Controls Page
5-32
Controller
Number
Controller
Destination
Description
81 MIDI 81 Default assignment for Switch 2
82 MIDI 82 Default assignment for Switch 3
83 MIDI 83 Default assignment for Switch 4
84 Portamento Standard MIDI controller for setting Portamento starting note
85 MIDI 85 Default assignment for Switch 5
86 MIDI 86 Default assignment for Switch 6
87 MIDI 87 Default assignment for Switch 7
88 MIDI 88 MIDI Controller 88
89 MIDI 89 Default assignment for Switch 8
90 MIDI 90 Default assignment for Switch 9
91–95 MIDI 91–95 MIDI Controllers 94–95
96 Data Inc Equivalent to pressing the Next Value button
97 Data Dec Equivalent to pressing the Previous Value button
98 NRegParL Non–Registered Parameter Least Signicant Byte
99 NRegParM Non–Registered Parameter Most Signicant Byte
100 RegParL Registered Parameter Least Signicant Byte
101 RegParM Registered Parameter Most Signicant Byte
102–109 MIDI 102–109 MIDI Controllers 102–109
110-119 MIDI 110–119 Reserved - Not available for use in the PC4 SE.
120 Sound Off Stops all sound in the corresponding channel.
121 RstCtls Resets Controllers to defaults in the corresponding channel.
122 Local Reserved for use by MIDI specication.
123 Notes Off Sends Note Off Message to all playing notes in the corresponding channel.
124 Poly Reserved for use by MIDI specication.
125 Omni Reserved for use by MIDI specication.
126 Mono On Reserved for use by MIDI specication.
127 Mono Off Reserved for use by MIDI specication.
128 Pitch Values above 64 and below 64 bend the pitch up and down, respectively.
129 PitchRev Values above 64 and below 64 bend the pitch down and up, respectively
130 PitchUp Values above 0 bend the pitch up
131 PitchDwn Values above 0 bend the pitch down
132 Pressure Default Destination for Pressure
133 Tempo Tempo
134 KeyNum
Triggers playback of notes by Key Number—e.g., C4 is 60. Send a velocity rst with
Destination 135, KeyVel.
135 KeyVel Key Velocity
136 ProgInc Program Increment—increments current Program number.
137 ProgDec Program Decrement—decrements current Program number.
138 ProgGoto Go to Program—selects Program.
139 MultiInc Multi Increment—increments current Multi number.
140 MultiDec Multi Decrement—decrements current Multi number.
141 SetpGoto Go to Multi—selects Multi.
145 TransUp Transpose Up (ST)