Kurzweil PC4 SE - Page 125

Multi Edit Mode
Controls Page
5-37
A Note About Octave Range
When using Shift Key Number, shift patterns with more than 12 steps begin triggering notes
in higher octaves. is is done because longer shift patterns use up more of a controller’s
range, and limit the number of octaves that a single controller can trigger. Since the lowest
octave of a program is often too low to be musically useful, the PC4 SE will automatically
start triggering notes from longer shift patterns in higher octaves. is saves room in the
controller’s range of values for triggering more useful octaves. See the table below for Shift
Pattern step ranges and their corresponding starting octave.
If Shift Key is set to Last Note Played and no note is played, the default key is C. Each zone
can have a dierent Shift Key, so you can have zones preprogrammed with the keys you want
to use, or have them all in the same key, or just change the key in real time while you are
playing.
Default Octave Shifting
Total # of Shift Pattern Steps Starting Octave
1-12 C0-C1
13-24 C1-C2
25-36 C2-C3
37-48 C3-C4
Selecting Octave Range
You can adjust the pattern’s starting octave by using the Add parameter on the Multi Edit
Controls page containing your ShKeyNum assignment. In the Add eld, the addition or
subtraction of the number of steps in your current shift pattern will raise or lower the starting
octave in relationship to the default starting octave. For example, in a shift pattern with
3 steps, an Add value of 9 would cause a controller value of 0 to make Shift Key Number
trigger notes in octave C3-C-4, 3 octaves above the default C0-C1. Add values that are not
multiples of the number of current shift pattern steps will change which step the pattern
begins on at controller value 0, thus osetting the relationship between all of the controller’s
values and current shift pattern’s steps. (See Add on page 5-28.)
Adjusting Controller Range
When using Shift Key Number, the number of steps in the Shift Pattern also aects the
range of values that will cause a controller to trigger a shift pattern step, and in turn aect
the useful range of the physical controller. With a shift pattern of 12 notes, the 128 dierent
notes that the PC4 SE can trigger are evenly spaced over the range of the controller. Patterns
with less than 12 steps will trigger notes in every octave over a shorter range of the controller.
For example, in a shift pattern with 3 steps, by default the controller values 0 to 2 will trigger
notes starting in the lowest possible octave, and controller values 27 to 30 will trigger notes
in the highest possible full octave. Using a or this controller, only about 1/4th of the length
of the slider would be triggering notes. is decreased useful range makes the controller
harder to use accurately. To remedy this, you can adjust a controllers behavior by using the
Scale parameter on the Multi Edit Controls page containing your ShKeyNum assignment.
Adjust the Scale value to stretch the useful values of the controller across it’s whole physical
range. A scale value of less than 100% will be helpful for patterns with fewer than 12 steps.