Kurzweil PC4 SE - Page 142

Global Mode
MIDI Page
6-14
Xmit Transport
Use the Xmit Transport parameter to enable or disable transmitting of System Real-Time and
MMC (MIDI Machine Control) Play and Stop transport messages from the PC4 SE’s MIDI
Out or USB ports.
When Xmit Transport is set to O, the PC4 SE will not send System Real-Time and MMC
transport messages.
When Xmit Transport is set to On, the PC4 SE’s front panel Play and Stop buttons will send
System Real-Time and MMC transport Play and Stop messages. is allows you to use the
PC4 SE to start or stop an external sequencer (if it is able to receive these messages).
Xmit Velocity Map
e Xmit Velocity Map parameter allows you to select a velocity map for MIDI notes
transmitted from the USB or MIDI Out ports. is is useful for adjusting the overall velocity
sensitivity for MIDI notes sent to external MIDI instruments. Dierent maps generate
dierent MIDI velocity values for the same physical key strike velocity. e default map
(Linear) provides the widest range of velocity expression. e Light and Hard maps make
it increasingly easier or harder to produce high MIDI velocity values for the same key strike
velocity (with Light3 being the easiest, Hard3 being the hardest). ese maps have the same
properties as the local Velocity Maps, for a description of each see “Velocity Map” on page
6-6.