Kurzweil PC4 SE - Page 56

Program Edit Mode
Arpeggiator Page
3-13
You can save your current settings as an Arp Preset by pressing the FAVORITES 1 button. If
you select a dierent Arp Preset before saving your current Arpeggiator settings, the current
Arpeggiator settings will be replaced by the settings from the preset without showing a
warning. Be sure to save your settings as an Arp Preset if you want to be able to recall them
after making additional changes. Even if you don’t save the current Arpeggiator settings as an
Arp Preset, the most recent settings will always be saved with the Program or Multi when the
Program or Multi is saved. Changing any of the Arp parameters will change the Preset to “0
Edited Arp”, to indicate that the previous preset settings are no longer being used.
Save Arp Preset
If you have adjusted any Arpeggiator settings, you have the option of saving a new Arp Preset
to a User location, where it will be available to use with other Programs and Multis. All
settings on the Arpeggiator page are saved as part of the Arp Preset, except for the State and
Key Range parameters, which are stored with the Program/Multi. If you don’t save an Arp
Preset, the arpeggiator settings will still be saved with the current Program or Multi.
In Program Edit Mode, press the FAVORITES 1 button to initiate a save. In Multi Edit
Mode, press the SAVE button to initiate a save. You will have the option to select the ID
number and name for your Arp Preset.
State
Use the State parameter to turn the Arpeggiator On or O.
In Program Mode, the State parameter can also be controlled by pressing the ARP button in
the front panel ARPEGGIATOR section, or by a switch pedal by setting one of the Global
Mode SW Override parameters to Arp On/O (see Switch Pedal Overrides on page 6-8).
In Multi Mode, the State parameter is shown for each Zone in the Arpeggiator column of the
Arpeggiator, CC Sequencer and Ri page.
In Multi Mode, State can also be controlled in each Zone by the front panel ARP button, by
another controller, or by one of the Global Mode SW Override parameters. To control State
with the front panel ARP button, in each Multi the ARP button must be assigned for each
Zone on the Multi Edit Controls page by setting the Controller Mode to MIDI CC, MIDI
Dest to 147 (Arp On/O), On Value to 127 and O Value to 0. State can also be controlled
with other controllers on the Multi Edit Controls page by using Destination 147 (Arp On/
O).