Kurzweil SP5-8 Service Manual

4-1
Chapter 4
Disassembly/Assembly
Introduction
This chapter contains the procedures and illustrations for the disassembly and reassembly of
the SP5-8. There are three sections: Opening the SP5-8, Top Enclosure, and Bottom Enclosure.
Notes, Cautions, Warnings
Please pay special attention to all Notes, Cautions, and Warnings as they not only point out
specic instructions.
Cables, Connectors
Most of the cables with connectors are keyed, and therefore cannot be reversed. If a cable’s
connector is not keyed, the disassembly instructions will caution you.
Throughout the top and bottom enclosures some cable assemblies are bundled together and
secured to the enclosure(s) with mounted head cable wraps. These cable wraps have exible
tabs and do not need to be cut; just unwrap the exible tab to release the bundled cables.
Unless otherwise noted, you do not need to unscrew the cable wrap from its position.
Standard plastic tie wraps are also used to bundle cables. Unless the service you are
performing requires it, do not cut the tie wraps. Should you need to do so, be sure to install
new tie wraps.
In some cases, tape fastens cables to PCBs or the enclosure. When disconnecting cable(s),
always peel back the tape from one side so that the tape remains properly positioned.
Required Tools and Materials
• No. 1 Phillips head screwdriver
• No. 2 Phillips head screwdriver
• 7/16” nut driver
• needle-nose pliers
• Small blunt-end tool (Q-Tip, toothpick, etc.)
• Foam or soft surface to protect the control panel, the keyboard and other delicate pieces

Kurzweil SP5-8 Specifications

General

Keyboard number of keys	88
MIDI-keyboard number of keys	- keys
Product color	Black
Pitch bend wheel	Yes
Interface	USB
Headphone outputs	1
Input voltage	15 V
Power source type	DC
Power consumption (typical)	15 W

Weight and Dimensions

Depth	350 mm
Width	1392 mm
Height	120 mm
Weight	21000 g