Top Enclosure
Replacing the Top Enclosure
4-4
1. Refer to Figure 4-2. Loosen the two guide screws. You do not need to remove these
screws.
2. Remove the remaining six screws that secure the top enclosure to the bottom enclosure.
3. Lift the top enclosure straight up a few inches.
Caution: Table 4-1 lists the cables that connect assemblies from the bottom enclosure to
the top enclosure. Unless the service you are performing requires it, you do not need to
disconnect these cables
4. Turn the top enclosure over and place it face down on your work surface.
endcap clamping
bracket
Figure 4-4
Bottom Enclosure Top Enclosure
Keyboard Bass Right Front Panel PCB
Keyboard Treble Right Front Panel PCB
Wheels Left Front Panel PCB
Key Pressure (white) Left Front Panel PCB
Key Pressure (black) Left Front Panel PCB
Table 4-1 Top and bottom enclosure cables
Replacing the Top Enclosure
1. Position the top enclosure behind the bottom enclosure.
2. All cables should be connected and bundled.
3. Lift the top enclosure over the bottom enclosure, then lower it on to the bottom
enclosure. Use the guide screws to correctly position the top enclosure.
To Next Page
Loading...
