Top Enclosure
Opening the SP5-8
4-2
Top Enclosure
Opening the SP5-8
Refer to Figure 4-1. Arrows indicate the locations of the enclosure support wall and endcap
screws.
1. Position the SP5-8 so that its rear panel portion hangs over the edge of your work
surface. This should give you enough room to access the six screws that secure the
enclosure support walls.
2. Remove the six enclosure support wall screws.
3. Slide the unit back on your work surface.
Caution: At this point of the procedure, do not remove the endcap screws or the screws
located in the “grayed out” portion of the illustration below.
Enclosure Support Wall screws
Rear Panel
Endcap screws
*Endcap locking bracket screws
*
*
Figure 4-1 SP5-8 bottom enclosure, hardware locations
screws
Rear Panel screws
guide
guide
Figure 4-2 SP5-8 rear panel, hardware locations
To Next Page
Loading...
