Kyocera FS-1028MFP

2H9
1-5-34
1-5-8 Fuser section
(1) Detaching and refitting the fuser unit
Procedure
1. Remove the left cover and right cover (See
page 1-5-3).
2. Remove the wires from three clamps.
3. Remove the connector from the power
source PWB.
Figure 1-5-51
4. Unhook four hooks and then remove the
frame left duct.
5. Remove the wires from the clamp.
Figure 1-5-52
YC105
Clamp
Clamps
Connctor
Power source
PWB
Power source
PWB
Frame left duct
Frame left duct
Hook
Clamp
Wires
Hook
Hook
Hook