Kyocera FS-1028MFP

2H9
2-3-11
YC105 1 +3.3V1 O 3.3 V DC 3.3 V DC power source
Connected
to the
optional DP
(DP driver
PWB)
2 GND - - Ground
3 TIMSWN I 0/3.3 V DC DP timing sensor: On/Off
4 ORGSWN I 0/3.3 V DC DP original sensor: On/Off
5 OPSWN I 0/3.3 V DC DP open/close sensor: On/Off
6 DPDETN I 0/3.3 V DC DP installation detection signal
7 RELSOLN O 0/24 V DC DP switchback pressure solenoid: (Release) On/Off
8 PRESOLN O 0/24 V DC DP switchback pressure solenoid (Press.): On/Off
9 REVSOL O 0/24 V DC DP switchback feedshift solenoid: On/Off
10 FEEDCL O 0/24 V DC DP paper feed clutch: On/Off
YC108 1 MOT1A O 0/24 V DC (pulse) DP paper feed motor drive pulse
Connected
to the
optional DP
(DP driver
PWB)
2 MOT2B O 0/24 V DC (pulse) DP paper feed motor drive pulse
3 MOT1B O 0/24 V DC (pulse) DP paper feed motor drive pulse
4 MOT2A O 0/24 V DC (pulse) DP paper feed motor drive pulse
5 +24V4 O 24 V DC 24 V DC power source
6 GND - - Ground
YC109 1 +24V4 O 24 V DC 24 V DC power source
Connected
to the
optional DP
(DP driver
PWB)
2 GND - - Ground
Connector Pin Signal I/O Voltage Description