2H9-1
1-3-13
U051
Adjusting the deflection in the paper
Description
Adjusts the deflection in the paper.
Purpose
Make the adjustment if the leading edge of the copy image is missing or varies randomly, or if the copy paper
is Z-folded.
Adjustment
1. Press the start key.
2. Select the item to be adjusted using the cursor up/down keys.
3. Press the system menu/counter key.
4. Place an original and press the start key to make a test copy.
5. Press the system menu/counter key.
6. Change the setting value using the cursor left/right keys or numeric keys.
For output example 1, increase the value. For output example 2, decrease the value.
The greater the value, the larger the deflection; the smaller the value, the smaller the deflection.
Figure 1-3-3
7. Press the start key. The value is set.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
Maintenance
item No.
Description
Display Description Setting
range
Initial
setting
Change in
value per step
DELAY BASE Adjustment of deflection in the paper -128 to 127 0 1 mm
REGIST CAS1 Paper feed from cassette -128 to 127 0 1 mm
REGIST CAS2 Paper feed from optional cassette -128 to 127 0 1 mm
REGIST CAS3 Paper feed from optional cassette -128 to 127 0 1 mm
DUPLEX Duplex mode (second side) -128 to 127 0 1 mm
Original Copy
example 1
Copy
example 2
To Next Page
Loading...
