2KT/2KV
1-5-29
(3) Detaching and refitting the main PWB
Procedure
1. Remove the hard disk* or network inter-
face card, if installed.
*: 26/28 ppm model only
2. Remove the IF cover (see page 1-5-3).
3. Remove two pins and then remove the
hard disk or network interface card.
Figure 1-5-41
4. Remove the top cover (see page 1-5-3).
5. Remove the right rear cover, right cover
and right lower cover (see page 1-5-5).
6. Remove three screws and then remove
the power source shield.
Screws A and B are unidentical, there-
fore, do not mix up.
Figure 1-5-42
Pin
Pin
Hard disk
Power source shield
Screw B
Screw
Screw A
To Next Page
Loading...
