2DC
1-6-52
Figure 1-6-62
Enter maintenance mode.
Press the start key
Enter “071” using the copy exposure
adjustment keys or zoom +/- keys.
Yes
No
Start
End
• For copy example 1,
decrease the value using
the zoom (-) key.
• For copy example 2,
increase the value using
the zoom (+) key.
Press the program key and the
machine enters the test copy mode.
Press the stop/reset key
to exit maintenance mode..
Place an original on the DP
and make a test copy.
Is the image correct?
Setting range: –42 – +32
Initial setting: 0
Changing the value by 1 moves
the copy image by 0.254 mm.
Press the start key.
The new setting is stored.
Select “Exp. 2” (DP trailing edge
registration) using the copy
exposure adjustment keys.
Original Copy
example 1
Copy
example 2
(12) Adjusting the DP trailing edge registration
Perform the following adjustment if the original scanning end position is not correct when the DP is used.
Caution:
If the copy image looks like copy example 2, clean the DP original scanning section.
Procedure
To Next Page
Loading...
