Kyocera KM-1500 - DELM - DELete Macro

2DC
1-5-9
Code Contents
Remarks
Causes Check procedures/corrective measures
C0610
(A0610*)
C0620
(A0620*)
C0630
(A0630*)
C0800
(A0800*)
C2000
(A2000*)
C3100
(A3100*)
Bitmap (DIMM) problem
• There is a problem with the data or
address bus of the bitmap DRAM.
Memory input interface problem
• Reading-in of an image does not
complete within 10 s of the start of
image transmission.
DMA problem
• DMA transmission of compressed,
decompressed, rotated, relocated or
blanked-out image data does not
complete within the specified period
of time.
Image processing problem
• JAM05 is detected twice.
Main motor problem
• LOCK ALM signal remains high for 1
s, 1 s after the main motor has turned
on.
Scanner carriage problem
• The home position is not correct
when the power is turned on or copy-
ing the document placed on the con-
tact glass.
Defective main
board (KP-5060).
DIMM installed
incorrectly.
Defective DIMM.
Defective main
board (KP-5060).
Defective main
board (KP-5060).
Defective engine
board (KP-5061).
Poor contact in
the main motor
connector termi-
nals.
Defective main
motor rotation
control circuit.
Defective drive
transmission sys-
tem.
Poor contact of
the connector ter-
minals.
Defective scanner
home position
sensor.
Defective engine
board (KP-5061)
or scanner board
(KP-5063).
Defective scanner
motor.
Replace the main board (KP-5060) and
check for correct operation.
Check if the DIMM is inserted into the
socket on the main board (KP-5060) cor-
rectly.
Replace the DIMM and check for correct
operation.
Replace the main board (KP-5060) and
check for correct operation.
Replace the main board (KP-5060) and
check for correct operation.
Replace the engine board (KP-5061) and
check for correct operation.
Reinsert the connector. Also check for con-
tinuity within the connector cable. If none,
remedy or replace the cable.
Replace the main motor.
Check if the rollers and gears rotate
smoothly. If not, grease the bushings and
gears. Check for broken gears and replace
if any.
Check the connection of connectors YC10,
11 on the engine board (KP-5061) and the
continuity across the connector terminals.
Repair or replace if necessary.
Replace the scanner home position sen-
sor.
Replace the engine board (KP-5061) or
scanner board (KP-5063) and check for
correct operation.
Replace the scanner motor.
“A” is displayed on the market.