2DA/2DB
1-5-8
(4)
A paper jam in the
paper feed section is
indicated during
copying (no paper
feed from the drawer
2).
Jam code 12
Paper in the first paper
feeder*
2
is extremely
curled.
Change the paper.
Check if the paper feed pul-
ley, separation pulley or for-
ward pulley in the first paper
feeder*
2
is deformed.
Check visually and replace any deformed pulley.
Broken registration switch
actuator.
Check visually and replace registration switch if its actuator is bro-
ken.
Defective registration
switch.
Run maintenance item U031 and turn registration switch on and
off manually. Replace registration switch if indication of the corre-
sponding switch is not light.
Check if the drawer paper
feed clutch 1*
2
malfunc-
tions.
Run maintenance item U032 and select the drawer paper feed
clutch 1 to be turned on and off. Check the status and remedy if
necessary.
Electrical problem with the
drawer paper feed clutch
1*
2
.
Check.
(5)
A paper jam in the
paper feed section is
indicated during
copying (no paper
feed from the drawer
3).
Jam code 13
Paper in the second paper
feeder*
1
is extremely
curled.
Change the paper.
Check if the paper feed pul-
ley, separation pulley or for-
ward pulley in the second
paper feeder*
1
is deformed.
Check visually and replace any deformed pulley.
Broken drawer feed switch
1*
2
actuator.
Check visually and replace drawer feed switch 1 if its actuator is
broken.
Defective drawer feed
switch 1*
2
.
Run maintenance item U031 and turn drawer feed switch 1 on
and off manually. Replace drawer feed switch 1 if indication of the
corresponding switch is not light.
Check if the drawer paper
feed clutch 2*
1
malfunc-
tions.
Run maintenance item U032 and select the drawer paper feed
clutch 2 to be turned on and off. Check the status and remedy if
necessary.
Electrical problem with the
drawer paper feed clutch
2*
1
.
Check.
(6)
A paper jam in the
paper feed section is
indicated during
copying (no paper
feed from the drawer
4).
Jam code 14
Paper in the third paper
feeder*
1
is extremely
curled.
Change the paper.
Check if the paper feed pul-
ley, separation pulley or for-
ward pulley in the third
paper feeder*
1
is deformed.
Check visually and replace any deformed pulley.
Broken drawer feed switch
2*
1
actuator.
Check visually and replace drawer feed switch 2 if its actuator is
broken.
Defective drawer feed
switch 2*
1
.
Run maintenance item U031 and turn drawer feed switch 2 on
and off manually. Replace drawer feed switch 2 if indication of the
corresponding switch is not light.
*1: Optional. *2: Optional for 16 ppm model. Standard for 20 ppm model.
Problem
Causes/check procedures
Corrective measures
To Next Page
Loading...
