Kyocera KM-1650

2DA/2DB
1-3-1
1-3 Installatio n
1-3-1 Unpacking and installation
(1) Installation procedure
Unpacking.
Install the optional paper feeder.
Remove the tapes and pins.
Install the original cover or the optional DP.
Connect the power cord.
Load paper.
Make test copies.
Output an own-status report
(maintenance item U000).
Exit maintenance mode.
Start
Install the toner container.
Installing the toner
(maintenance item U130).
Install the optional duplex unit.
Install the optional finisher or job separator.
End of installation.