Kyocera KM-1650

2DA/2DB-3.0
1-5-18
(2) Self diagnostic codes
Code Contents
Remarks
Causes Check procedures/corrective measures
C0030
Fax control PCB*
1
system problem
Processing with the fax software was
disabled due to a hardware or software
problem.
Defective fax con-
trol PCB.
Replace the fax control PCB and check for
correct operation.
C0070
Fax control PCB*
1
incompatibility
detection problem
Fax software is not compatible with main
software.
Fax software or
main software is
something of the
other machine.
Check the version of the Fax software and
the main software, upgrade the version to
the compatible software.
C0100 Backup memory read/write problem
(main PCB flash)
Read and write data does not match.
Defective main
PCB.
Replace the main PCB and check for correct
operation.
C0110 Backup memory data problem (main
PCB flash)
Data in the specified area of the backup
memory does not match the specified
values.
Problem with the
backup memory
data.
Turn safety switch off and back on and run
maintenance item U020 to set the contents
of the backup memory data again.
Defective backup
RAM.
If the C0110 is displayed after re-setting the
backup memory contents, replace the main
PCB.
C0130 Backup memory read/write problem
(main PCB EEPROM)
Read and write data does not match.
Defective
EEPROM or main
PCB.
Replace the main PCB and check for correct
operation.
C0140 Backup memory data problem (main
PCB EEPROM)
Data in the specified area of thebackup
memory does not match the specified
values.
Problem with the
backup memory
data.
Turn safety switch off and back on and run
maintenance item U020 to set the contents
of the backup memory data again.
Defective
EEPROM.
If the C0140 is displayed after re-setting the
backup memory contents, replace the
EEPROM or main PCB.
C0150 Backup memory read/write problem
(engine PCB)
Read and write data does not match.
Defective engine
PCB.
Replace the engine PCB and check for cor-
rect operation.
C0160 Backup memory data problem (engine
PCB)
Data in the specified area of the backup
memory does not match the specified
values.
Problem with the
backup memory
data.
Turn safety switch off and back on and run
maintenance item U020 to set the contents
of the backup memory data again.
Defective backup
RAM.
If the C0160 is displayed after re-setting the
backup memory contents, replace the
engine PCB.
C0170 Accounting count problem
When the power is turned on, the total
count and the scan count are abnormal
both on the main PCB and the engine
PCB.
Defective main
PCB or engine
PCB.
Replace the main PCB or engine PCB and
check for correct operation.
C0180 Machine number mismatch
When the power is turned on, the
machine number does not match
between the main PCB and the engine
PCB.
Correct EEPROM
is not installed.
Install the correct EEPROM. If it does not
solve the problem, contact the Service
Administrative Division.
Data damage of
EEPROM.
Contact the Service Administrative Division.
*1: Optional. *2: Optional for 16 ppm model. Standard for 20 ppm model.