Kyocera KM-1650 - The Leading Edge of the Image Is Sporadically Misaligned with the Original; Paper Creases; Offset Occurs

2DA/2DB
1-5-31
(12)The leading edge of the image is
sporadically misaligned with the
original.
Causes
1. Paper feed clutch, bypass paper feed solenoid or registration motor installed
or operating incorrectly.
Causes Check procedures/corrective measures
1. Paper feed clutch, bypass paper feed
solenoid or registration motor installed or
operating incorrectly.
Check the installation position and operation of the paper feed clutch,
bypass paper feed solenoid and registration motor. If any of them oper-
ates incorrectly, replace it.
(13)Paper creases.
Causes
1. Paper curled.
2. Paper damp.
3. Defective pressure springs.
4. Defective separation.
5. Dirty separation electrode.
Causes Check procedures/corrective measures
1. Paper curled.
Check the paper storage conditions.
2. Paper damp.
Check the paper storage conditions.
3. Defective pressure springs.
Replace the pressure springs.
4. Defective separation.
Check the drum separation claws and heat roller separation claws.
5. Dirty separation electrode.
Clean the separation electrode.
(14)Offset occurs.
Causes
1. Defective cleaning blade.
2. Defective fixing section.
Causes Check procedures/corrective measures
1. Defective cleaning blade.
Replace the drum unit (see page 1-6-38).
2. Defective fixing section.
Check the heat roller and press roller.