2DA/2DB
1-5-13
(16)
A paper jam in the
exit section is indi-
cated during copying
(misfeed in the exit
section).
Jam code 50
Check if the registration
motor malfunctions.
Run maintenance item U030 and select the registration motor to
be turned on and off. Check the status and remedy if necessary.
Electrical problem with the
registration motor.
Check (see page 1-5-34).
(17)
A paper jam in the
exit section is indi-
cated during copying
(misfeed in the job
separator).
Jam code 51
Broken feedshift switch
actuator.
Check visually and replace the feedshift switch if its actuator is
broken.
Defective feedshift switch. Run maintenance item U031 and turn feedshift switch on and off
manually. Replace feedshift switch if indication of the correspond-
ing switch is not light.
Broken Job separator eject
switch*
1
actuator.
Check visually and replace the Job separator eject switch if its
actuator is broken.
Defective Job separator
eject switch*
1
.
Run maintenance item U031 and turn Job separator eject switch
on and off manually. Replace Job separator eject switch if indica-
tion of the corresponding switch is not light.
(18)
A paper jam in the
feedshift section is
indicated during
copying (misfeed in
the feedshift section).
Jam code 52, 53, 54,
55, 56, 57
Broken feedshift switch
actuator.
Check visually and replace the feedshift switch if its actuator is
broken.
Defective feedshift switch. Run maintenance item U031 and turn feedshift switch on and off
manually. Replace feedshift switch if indication of the correspond-
ing switch is not light.
Check if the exit motor mal-
functions.
Run maintenance item U030 and select the exit motor to be
turned on and off. Check the status and remedy if necessary.
Electrical problem with the
exit motor.
Check (see page 1-5-34).
(19)
A paper jam in the
duplex section is indi-
cated during copying
(misfeed in duplex
paper conveying sec-
tion).
Jam code 60
Broken feedshift switch
actuator.
Check visually and replace the feedshift switch if its actuator is
broken.
Defective feedshift switch. Run maintenance item U031 and turn feedshift switch on and off
manually. Replace feedshift switch if indication of the correspond-
ing switch is not light.
Broken duplex paper con-
veying switch*
1
actuator.
Check visually and replace the duplex paper conveying switch if
its actuator is broken.
Defective duplex paper con-
veying switch*
1
.
Run maintenance item U031 and turn duplex paper conveying
switch on and off manually. Replace duplex paper conveying
switch if indication of the corresponding switch is not light.
Check if the exit motor mal-
functions.
Run maintenance item U030 and select the exit motor to be
turned on and off. Check the status and remedy if necessary.
Electrical problem with the
exit motor.
Check (see page 1-5-34).
Check if the duplex feed
clutch*
1
malfunctions.
Check visually and remedy if necessary.
Electrical problem with the
duplex feed clutch*
1
.
Check.
*1: Optional. *2: Optional for 16 ppm model. Standard for 20 ppm model.
Problem
Causes/check procedures
Corrective measures
To Next Page
Loading...
