Kyocera KM-1650

2DA/2DB-1
1-3-9
Installing the drawer heater (option)
Drawer heater installation requires the following parts:
Drawer heater (P/N 120 V specifications: 2A727480, 220-240 V specifications: 2A727490)
Ground plate (P/N 3BG02060)
Drawer heater mounting plate (P/N 3HW02030)
One (1) M3 x 6 tap-tight S binding screw (P/N B3023060)
<Procedure>
1. Remove the rear cover of the paper feeder.
2. Pull out the drawer.
3. Fit the drawer heater to the hook on the
drawer heater mounting plate.
Mount the heater so that the projection of
the drawer heater mounting plate is inserted
into the hole of the drawer heater.
* After mounting, check that the projection is
securely inserted into the hole and that the
drawer heater does not move forward/back-
ward or right/left.
4. Fit the ground plate to the drawer heater
mounting plate using the M3 x 6 taptite S
binding screw.
Figure 1-3-9-1
5. Insert the drawer heater mounting plate
from the front side of the machine, pass the
drawer heater wire through the hole on the
frame at the rear side of the machine, and
pull the wire out from the rear side of the
machine.
6. Fit the two holes at the rear of the drawer
heater mounting plate to the fitting portions
at the rear side of the machine.
Figure 1-3-9-2
Drawer heater
Projection
Drawer heater
mounting plate
Hook
Hook
Ground plate
M3 x 6 taptite
S binding screw
Fitting portion
Fitting portion
Drawer heater wire
Drawer heater
mounting plate
Hole
1-3-8-1