2DA/2DB
1-3-33
Hole
Right hook
Groove
Copy tray
Attach the copy tray.
12. Insert the left part of the copy tray into the
groove of the job separator. Fit the right
hook into the hole located inside of MFP
while pushing the copy tray to the back
along the groove.
Figure 1-3-61
Attach the left front cover JS.
13. Pull out the connector of the job separator
from the hole of the left front cover that has
been removed by Procedure 4 and then
attach the left front cover to its original posi-
tion using the screw.
Figure 1-3-62
Screw
Left front
cover
Connector
To Next Page
Loading...
