2DA/2DB
1-4-16
U070
Adjusting the DP magnification
Description
Adjusts the DP original scanning speed.
Purpose
To be executed if the correct magnification is not obtained in the auxiliary scanning direction when the optional
DP is used.
Caution
Before making this adjustment, ensure that the following adjustments have been made in maintenance mode.
Method
Press the start key. The screen for setting is displayed.
Setting
1. Select the item to be set using the up/down cursor keys. The selected item is displayed in reverse.
2. Change the setting using the left/right cursor keys.
Increasing the setting makes the image longer, and decreasing it makes the image shorter.
3. Press the start key. The value is set.
Interrupt copy mode
While this maintenance item is being performed, copying from an original can be made in interrupt copy
mode.
1. Press the interrupt key. The machine enters the interrupt copy mode.
2. Set the original and press the strat key.
To return to the screen for setting, press the interrupt key.
Completion
Press the stop/clear key at the screen for setting. The screen for selecting a maintenance item No. is dis-
played.
Maintenance
item No.
Description
U053 U065 U070
Display Description Setting range Initial
setting
Change in
value per step
CONVEY SPEED1 Original conveying motor
speed (simplex original)
-25 to +25 0 0.1%
CONVEY SPEED2 Original conveying motor
speed (duplex original)
-25 to +25 0 0.1%
To Next Page
Loading...
