Kyocera KM-2020

1-3-6
2C9
1-3-3 Installing the paper feeder (option)
<Procedure>
1. Place the copier on the paper feeder by aligning the
positioning insertion sections of the copier with the
positioning pins at the rear part of the paper feeder.
* When placing the copier, take care not to hit the
copier against the drawer, the pins or ground plate
of the paper feeder.
For stacking paper feeders for use:
Stack a paper feeder on another paper feeder by
aligning the positioning insertion sections of the first
paper feeder with the positioning pins at the rear
part of the second paper feeder. (Up to three paper
feeders can be stacked.)
2. If a type of paper that is not included in the
specifications for the standard sheet cassette size is
used, replace the cassette size sheet indication with
the supplied one.
3. Insert the copier power plug into the wall outlet and
turn the copier power switch on.
Load paper in the drawer and make test copies to
check the operation.
Figure 1-3-5
Figure 1-3-6
Figure 1-3-7
Paper feeder
Positioning pins
Positioning
pins
Positioning
pins
Cassette size
sheet indication