Kyocera KM-2020

Maintenance
Description
item No.
2C9
1-4-14
U071 Adjusting the DP scanning timing
Description
Adjusts the DP original scanning timing.
Purpose
To be executed if there is a regular error between the leading or trailing edges of the original and the copy
image when the optional DP is used.
Caution
Before making this adjustment, ensure that the following adjustments have been made in maintenance mode.
Method
Press the start key.
Setting
1. Select the item by lighting a copy exposure indicator using the copy exposure adjustment keys.
2. Change the setting using the zoom +/– keys.
Copy exposure
Description Setting range Initial setting
Change in
indicator value per step
Exp. 1 DP leading edge registration –32 to +32 0 0.254 mm
Exp. 2 DP trailing edge registration –42 to +32 0 0.254 mm
Decreasing the setting moves the copy image backward, and increasing it moves the copy image forward.
3. Press the start key. The value is set.
Interrupt copy mode
While this maintenance item is being performed, copying from an original can be made in interrupt copy mode.
Adjustment
1. In interrupt copy mode, make a copy using the DP.
2. Check the copy image and adjust the registration as follows.
For copy example 1, decrease the setting of exp.1.
For copy example 2, increase the setting of exp.1.
Figure 1-4-2
Completion
Press the stop/clear key while a selection item is displayed. The indication for selecting a maintenance item No.
appears.
U034 U066 U071
Original Copy
example 1
Copy
example 2