Job
8-19 KX Driver
5
Press the ENTER key, the user name displays with a blinking question mark [ ? ]. 5
6
If the user name is correct, press the ENTER key. Otherwise, press the S or T key
until the correct name is displayed. 6
7
The job name is displayed with a blinking question mark [ ? ]. Press the ENTER key.7
8
The user name displayed is specified following the instructions in Identification on
page 2-5. If this is the correct job for printing, press the ENTER key. 8
9
Otherwise, press the S or T key until the correct job name appears, then press the
ENTER key. 9
10
Enter the four-digit access code created in Private Print on page 8-18. 10
11
Press the S or T key to increase or decrease the number. 11
12
Press the W or X key to move the cursor right and left. 12
13
Press the ENTER key. Use the S or T key to specify the number of copies for
printing. 13
14
Press the ENTER key to start printing. 14
15
After printing, the job will be automatically deleted from the hard disk. To delete the
job without printing it, follow the same procedure as in Deleting Quick Copy Jobs on
page 8-17. 15
To Next Page
Loading...
