2K5
2-3-22
Connector Pin No. Signal I/O Voltage Description
YC3 1 SMOTA O 0/24 V DC (pulse) SM drive control signal (A)
Connected
to the scan-
ner motor
2 SMOTB O 0/24 V DC (pulse) SM drive control signal (B)
3 SMOTA_ O 0/24 V DC (pulse) SM drive control signal (_A)
4 SMOTB_ O 0/24 V DC (pulse) SM drive control signal (_B)
YC4 1 +5VSL I 5 V DC 5 V DC power input from MPWB
Connected
to the main
PWB
2 +5VSL I 5 V DC 5 V DC power input from MPWB
3 GND - - Ground
4 GND - - Ground
5 GND - - Ground
6 GND - - Ground
7 SLEEP I 0/3.3 V DC Sleep signal
8 GA_SO I 0/3.3 V DC (pulse) Serial communication data signal
9 GA_SRDY I 0/3.3 V DC (pulse) Ready signal
10 GA_OVM I 0/3.3 V DC Control signal
11 GA_SI O 0/3.3 V DC (pulse) Serial communication data signal
12 GA_SEL O 0/3.3 V DC Select signal
13 GA_SCLK O 0/3.3 V DC (pulse) Clock signal
14 PAGESTART O 0/3.3 V DC SPWB control signal
15 GND - - Ground
16 SC_RESN O 0/3.3 V DC SPWB reset signal
17 SC_SCLK I 0/3.3 V DC (pulse) SPWB clock signal
18 SC_SI I 0/3.3 V DC (pulse) SPWB serial communication data signal
19 SC_SO O 0/3.3 V DC (pulse) SPWB serial communication data signal
20 SC_SBSY O 0/3.3 V DC SPWB busy signal
21 SC_SDIR O 0/3.3 V DC SPWB communication direction signal
22 SC_IRN O 0/3.3 V DC SPWB interrupt signal
23 HLD_ScnN I 0/3.3 V DC SPWB scanner hold signal
24 CON10V O 0/3.3 V DC SPWB control signal
25 +3.3VSL I 3.3 V DC 3.3 V DC power input from MPWB
26 GND - - Ground
YC5 1 LAMPN O 0/24 V DC EL: On/Off
Connected
to the
inverter
PWB
2PGND -- Ground
3 +24VSL O 24 V DC 24 V DC power output to INPWB
4 +24VSL O 24 V DC 24 V DC power output to INPWB
5PGND -- Ground
6 LAMPN O 0/24 V DC EL: On/Off
To Next Page
Loading...
