Copying Functions
4-20 OPERATION GUIDE
The procedure for using Booklet copying is explained below.
1 Press the Copy key.
2 Place the originals on the platen.
3 Press [Layout/Edit] and then [Booklet].
4 Press [1-sided>>Booklet] to produce a booklet
from single-sided originals.
Press [2-sided>>Booklet] to produce a booklet
from two-sided originals.
Press [Book>>Booklet] to produce a booklet from
an open book original.
5 If you selected [2-sided>>Booklet] or
[Book>>Booklet], choose the binding orientation in
Finishing.
If you selected [1-sided>>Booklet], choose the
binding orientation in Finishing.
6 If you choose [1-sided>>Booklet],
[2-sided>>Booklet], or [Book>>Booklet] you can
add the cover. Press [Cover], select [Cover] and
press [OK].
7 Press [Original Orientation] to choose orientation of
the originals, either [Top Edge Top] or [Top Edge
Left]. Then press [OK].
8 If the optional 3,000 sheet document finisher and
folding unit are installed, the [Saddle Stitch] option
is displayed.
To use saddle stitching, press [Saddle Stitch] and
then press [Bind and Fold]. You can saddle stitch
up to 16 sheets (64 pages).
9 Press [OK].
10 Platen and press the Start key. Copying begins.
NOTE: When using the platen, be sure to place the
originals in page order.
If the originals are placed on the platen,
consecutively replace each original after pressing
the Start key.
After scanning all originals, press [Finish Scan] to
start copying.
To Next Page
Loading...
