Default Setting (System Menu)
OPERATION GUIDE 8-31
8
Entry Check for New Destination
When adding new destination, display the entry check screen to check the entered destination. The table below
shows the available settings.
Use the procedure below to set the destination check before send.
1 Press the System Menu key.
2 Press [Send] and then [Change] of Entry Check for New Dest.
3 Select [Off] or [On].
4 Press [OK].
Setting the Default Send Screen
Use this procedure to set the default screen displayed when you press the Send key.
The table below shows the available settings.
Use the procedure below to set the default send screen.
1 Press the System Menu key.
2 Press [Send] and then [Change] of Default Screen.
3 Press [Destination] or [Address Book].
4 Press [OK].
Item Description
Off Do not display the entry check screen.
On Display the entry check screen.
Item Detail
Destination Displays the destination screen when the Send key is pressed
(screen for sending).
Address Book Displays the address book when the Send key is pressed
To Next Page
Loading...
