Kyocera TASKalfa 650c

To Next Page

To Previous Page

4.PRINTING FROM UNIX/Linux

Printing from Application 129

4 PRINTING FROM UNIX/Linux

¦ Department Code

The department access code can be set using the following option.

– How the equipment performs printing for an invalid department code print job, for which an invalid department code

is specified, varies depending on the Department Code Enforcement setting that can be set from COMMAND

CENTER Administrator mode. When the Department Code Enforcement is set to "ON", the invalid department

code print job will be stored in the invalid department code print job list without printing. When the Department

Code Enforcement is set to "Print", the invalid department code print job will be printed. When the Department

Code Enforcement is set to "Delete", the invalid department code print job will be deleted without printing.

– For the appropriate department code, ask your system administrator.

¦ Smoothing

This sets whether to print text and graphics smoothly. This mode can be set using the following option.

Example: The command to set the smoothing mode is “lp -o smoothing=on <filename>”.

¦ Distinguish Thin Lines

This sets whether to distinguish thin lines or not. This mode can be set using the following option.

Example: The command to set the thin line limit mode is “lp -o thinlinelimit=on <filename>”.

¦ Do Not Print Blank Pages

This sets whether or not a blank page is printed. This mode can be selected using the following option.

Example: The command to set the blank page mode is “lp -o blankpage=0 <filename>”.

¦ Toner Save

The toner save mode can be set using the following option.

Example: The command to set the toner save mode is “lp -o tonersave=on <filename>”.