Labconco FlaskScrubber 4121010 Series User Manual

99
Poor washing
results
Water is not hot
enough.
Check Wash
water temperature
setting
. Should be at least
120°F (49°C).
Recommended
temperature is
150°F (66°C).
Improper loading
Check washer
loading
instructions in
Chapter 7 in this
manual.
Detergent too old or
amount wrong.
Replace detergent
or change quantity
used.
Detergent caked in
D- Cup.
Clean D-Cup.
Replace with fresh
detergent. Check
water inlet
temperature.
Should be at least
120°F (49°C).
Insufficient wash
time.
Increase wash cycle
time.
Wash arms not
spinning.
Remove and clean
wash arms.
Glassware
interfering with cup
door.
Move glassware.
Tank and inner door
have surface rust
Glassware is
contaminated with
acids.
Pre-rinse glassware.
Clean with stainless
steel cleaner and
soft cloth.
Washer does not
run
No power to washer.
Check fuse or circuit
breaker.
Improper wiring
Check wiring to
unit
Correct wiring
12 V power supply
Check power to
and out of 12V
power supply.
If input OK and
output 12VDC
replace power
supply
Washer door opens
and closes badly
Cabinet opening is
not square.
Correct opening with
leveling feet.
Door hitting counter-
top mounting
screws.
Adjust mounting
screws.
Door not sealing or
door too tight.
Adjust hinge pins or
door striker.
Washer leaks
Improper detergent.
Check detergent
for foaming.
Use non-foaming
detergent. Use only
proper amount of
detergent.

Labconco FlaskScrubber 4121010 Series Specifications

General

Brand	Labconco
Model	FlaskScrubber 4121010 Series
Category	Dishwasher
Language	English