Labconco Protector Echo 180 Series User Manual

Appendix E: gGuard
Product Service 1-800-522-7658
146
Original instructions
16. After you name the hood then press “Validate,” then “Confirm chosen
configuration,” “OK” to user manipulates hood, “Yes” (as shown below).
17. Now go back to the “Home Page”“Add/Delete a hood”“Add.” Now add the
next hood. Repeat this process until all the hoods have been added.
Tip: There are two options for setting up the GFH hoods for connectivity to a network.
One is with a “Static IP” the other is “Dynamic IP.” Option one is the most common
however, there may be cases (typically one hood installations) that will use option two.

Labconco Protector Echo 180 Series Specifications

General

Brand	Labconco
Model	Protector Echo 180 Series
Category	Laboratory Equipment
Language	English