TABLE OF CONTENTS
GENERAL SAFETY WARNINGS 4
GENERAL SAFETY OBLIGATIONS 4
1) DESCRIPTION OF THE MODELS 5
2) TECHNICAL SPECIFICATIONS 5
MECHANICAL SECTION
3) NEPTIS PLUS AUTOMATION COMPONENTS 6
4) PRELIMINARY CHECKS 7
5) TECHNICAL DRAWINGS 8
5.1) ASSEMBLY OF THE AUTOMATION ON THE TRANSOM FROM THE HINGE SIDE 8
5.2) ASSEMBLY OF THE AUTOMATION ON THE TRANSOM FROM THE HINGE SIDE 9
5.3) ASSEMBLY OF THE AUTOMATION ON THE TRANSOM FROM THE HINGE SIDE 10
5.4) ASSEMBLY OF THE AUTOMATION ON THE TRANSOM FROM THE SIDE OPPOSITE TO THE HINGE 11
5.5) ASSEMBLY OF THE AUTOMATION ON THE LEAF FROM THE HINGE SIDE 12
5.6) ASSEMBLY OF THE AUTOMATION ON THE TRANSOM FROM THE HINGE SIDE 13
6) MOVEMENT TRANSMISSION ARMS 14
6.1) SLIDE PULL ARM BDT2 14
6.3) SHORT SLIDE PULL ARM BDT2R55 15
6.4) SLIDING GUIDE FOR PULL ARM 15
6.5) BSS2 ARTICULATED PUSH ARM 15
6.6) EXTB-Z TAPERED PIN 16
6.7) EXTENSION FOR EXTB-Z TAPERED PIN 16
7) PREPARATION AND INSTALLATION OF THE AUTOMATION 17
7.1) TOOLS REQUIRED: 17
7.2) AUTOMATION CHECK 17
7.3) AUTOMATION INSTALLATION 18
7.4) CHOICE OF THE SPRING LOAD (FOR NEPTIS PLUS NB-LET, NB-LETB, NB-SLT, NB-SLTB AUTOMATIONS ONLY) 18
7.5) INSERTION OF THE ARM TAPERED PIN 18
7.6) SPRING RELEASE (FOR NEPTIS PLUS NB-LET, NB-LETB, NB-SLT, NB-SLTB AUTOMATIONS ONLY) 18
8) ARM REMOVAL 19
9) NEPTIS PLUS AUTOMATIONS WITH BATTERY (SLTB, LETB, SMTB MODELS) 20
10) SPRING PRE-LOAD RESETTING PROCEDURE (FOR SLT, SLTB, LET, LETB MODELS ONLY) 21
ELECTRONICS
11) ELECTRIC ARRANGEMENTS 22
12) ELECTRIC CONNECTIONS 23
13) PWB ELECTRICAL WIRING AND POWER SUPPLY MODULE 24
13.1) LOGIC CARD LCB 26
14) DIGITAL SELECTOR ET-DSEL – PURPOSE AND CONNECTIONS 26
15) SAFETY SENSORS 27
15.1) SAFETY SENSOR OA-EDGE T 27
15.2) FLAT SCAN SAFETY SENSOR 27
16) COMMISSIONING OF THE AUTOMATION (INITIAL SETUP) 28
16.1) FIRST START OF THE DIGITAL SELECTOR ET-DSEL 28
16.2) SERIAL COMMUNICATION SETTINGS 28
16.3) INITIAL SETUP 29
16.4) FUNCTIONAL TESTING 31
16.5) INPUT DIAGNOSTICS 31
To Next Page
Loading...
Need help?
General
