7
4) PRELIMINARY CHECKS
Before installing the automation, verify the following requirements:
• The support structure of the automation should be rm, with no signicant deformation.
• The structure of the leaf must be rigid and strong.
• The leaf hinges must be adequate and in good condition.
• The length and weight of the leaf must be within the operating limits of the automation.
• The movement of the leaf must be smooth and free of friction throughout the run.
• The door requires mechanical stops, consisting of a mechanical stop in open position and a nal stop in closed position.
The mechanical opening stop is not supplied with the automation.
In case the wall on which the automation is to be installed were not strong and reliable enough, you can purchase a pre-drilled
metal plate to which you can fasten the Neptis Plus automation.
There are two models of xing plates, FIXPLATE for the Neptis Plus automation without battery and FIXPLATE-P for the
Neptis Plus automation with built-in battery.
Soluzione/Solution
Braccio a slitta a tirare/Slide pull arm
Base Operator Neptis
FIXPLATE-P
To Next Page
Loading...
Need help?
General
