Label NEPTIS PLUS - Page 40

40
F44 Not used
F45m Not used
F48 Not used
F49
OFF*
It enables the buzzer warning beep when the motor thrust power limit is reached (refer to the paragraph
"Functional testing")
S
ON It disables the buzzer warning beep when the motor thrust power limit is reached.
F50 Not used
F51 Not used
F52 Not used
F53 Not used
F54 Not used
F55 Not used
F56 Not used
F57 Not used
F58 Not used
F59 Not used
F60 Not used
F61 Not used
F62 Not used
F63 Not used
F64 Not used
F65 Not used
F66 Not used
F67 Not used
F68 Not used
F69 Not used
F70 Not used
F71 Not used
F72 Not used
F73
OFF* Opening leaf braking stage start in advance with relation to the end of the manoeuvre. S
ON Opening leaf braking stage start corresponding to the last degrees of the manoeuvre.
F74 Not used
F75 Not used
F76 Not used
F77
OFF* Privacy function disabled
ON Privacy function enabled (refer to the paragraph "PRIVACY FUNCTION")
F78
Function
enabled if the
function F77
= ON
OFF*
for electromagnet not equipped with open/closed status sensor (factory setting).
The Neptis Plus automation automatically detects the closed door status.
ON
ONLY READ IF YOU INSTALLED AN ELECTROMAGNET EQUIPPED WITH AN OPEN/CLOSED STATUS SENSOR
(not supplied by Label)
for electromagnet equipped with open/closed status sensor. Connect the N.O. output contact of the
electromagnet built-in status sensor to the AUX1 input of the PWB control unit to detect the closed door
status.
F79
Function
enabled if the
function F77
= ON
OFF The signaling light (D) is steadily green while the door is moving and waiting for the door lock command.
ON*
The signaling light (D) alternately switches between red and green; it ashes slowly while the door is
moving, and fast when the door is waiting for the door lock command.
When the door is closed the light is always steadily red.
F80
OFF* Cyclic function OFF
ON
Cyclic function ON.
It activates the continuous door opening and closing cycle; it is used only for operation tests or durability
tests.