Operation
CoaDATA 501 – Operators Manual 2.1 Page 33
You can control the function of the automatic cuvette detection with this
menu.
CUV-TEST
cuv
If no cuvette is located in the measuring channel the display (-----) appears.
If a cuvette was placed in the measuring channel the display cuv appears.
The display will show the respective status once a cuvette is placed into or
removed from the analyzer.
• Press Enter to leave the menu.
2.3 Printer
It is possible to link an external printer (optional) to the analyzer, refer to
chapter 1.3.1 Connect an external printer. The connection to the printer
shall be done via the RS 232C interface of the analyzer. Ask your local
dealer for recommended printer models.
To Next Page
Loading...