EasyManuals Logo

LabJack U3 User Manual

LabJack U3
120 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #76 background imageLoading...
Page #76 background image
Errorcode
Name Description
36 LJE_TIMER_INVALID_MODE
39 LJE_TIMER_BAD_CLOCK_SOURCE
40 LJE_TIMER_STREAM_ACTIVE
41 LJE_TIMER_PWMSTOP_MODULE_ERROR
42 LJE_TIMER_SEQUENCE_ERROR
43 LJE_TIMER_SHARING_ERROR
44 LJE_TIMER_LINE_SEQUENCE_ERROR
45 LJE_EXT_OSC_NOT_STABLE
46 LJE_INVALID_POWER_SETTING
47 LJE_PLL_NOT_LOCKED
48 LJE_INVALID_PIN
49 LJE_IOTYPE_SYNCH_ERROR
50 LJE_INVALID_OFFSET
51 LJE_FEEDBACK_IOTYPE_NOT_VALID
52 LJE_SHT_CRC
53 LJE_SHT_MEASREADY
54 LJE_SHT_ACK
55 LJE_SHT_SERIAL_RESET
56 LJE_SHT_COMMUNICATION
57 LJE_AIN_WHILE_STREAMING AIN not available to command/response
functions while the UE9 is streaming.
58 LJE_STREAM_TIMEOUT
60 LJE_STREAM_SCAN_OVERLAP New scan started before the previous scan
completed. Scan rate is too high.
61 LJE_FIRMWARE_VERSION_IOTYPE IOType not supported with this firmware.
62 LJE_FIRMWARE_VERSION_CHANNEL Channel not supported with this firmware.
63 LJE_FIRMWARE_VERSION_VALUE Value not supported with this firmware.
64 LJE_HARDWARE_VERSION_IOTYPE IOType not supported with this hardware.
65 LJE_HARDWARE_VERSION_CHANNEL Channel not supported with this hardware.
66 LJE_HARDWARE_VERSION_VALUE Value not supported with this hardware.
37 LJE_TIMER_QUADRATURE_AB_ERROR
38 LJE_TIMER_QUAD_PULSE_SEQUENCE
76
Table 4-2. Request Level Error Codes (Part 2)

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the LabJack U3 and is the answer not in the manual?

LabJack U3 Specifications

General IconGeneral
Analog Outputs2
Analog Output Resolution10 bits
Digital I/O20
Counter/Timers2
InterfaceUSB
Operating Voltage5 V
ManufacturerLabJack Corporation
Analog Inputs16
Analog Input Resolution12-bit
Max Sample Rate50 kHz