PL1220 Owner’s Manual
32
Verify wiring is correct according to local electric code. All
needed electrical information can be found in the Electrical
Safety Section
NOTE
It is recommended to use a power strip with an on/off switch
to give power to the machine and all components at the same
time and to turn them on and off easily.
11. With all components plugged in, run the confirmation of proper set-up test.
After Setup, there may be a few adjustments to be made. All of these adjustments are made prior
to shipping the saw, but if one is found to need adjustments, please follow the adjustment guides.
6.2 Unboxing
This machine is heavy. Seek assistance from an experienced
professional if you have any doubt about the following
unboxing or set up procedures.
DO NOT attempt any procedure that you feel is unsafe or you
believe you do not have the physical capability of achieving.
CAUTION
DO NOT cut deep into the wooden crate with a blade as it may
scratch the paint.
To Next Page
Loading...
