Laguna Tools PL1220 - Laser Machine Assembly and Leveling

PL1220 Owner’s Manual
34
6.3 Laser Machine Assembly and Leveling
DANGER
DO NOT plug in the PL1220 machine until setup and assembly
is complete.
1. Carefully unbox the PL1220 laser machine.
2. With two (2) people, lift and place the PL1220 laser machine on a level floor or desired
surface.
CAUTION
The machine is heavy and requires at least two (2) people to
lift it into position.
a. If using the Z-Axis base (optional), place the base on a floor or desired surface and
level the base by adjusting the pads on the bottom.
b. Verify the base is level.
c. With two (2) people, lift and place the PL1220 laser machine on top of the base and
level the PL1220 to the base if needed.
WARNING
Use caution when placing the PL1220 on the base, it is NOT
bolted down and the laser tube can break if it drops from the
foot pad.