Laguna Tools PL1220 - Maintenance; General; Drive Belt & Bearings; As Needed

PL1220 Owner’s Manual
73
12.0 Maintenance
DANGER
Unplug the machine prior to any maintenance work.
Always unplug the machine when changing the blade, guards,
or any maintenance.
12.1 General
Keep the machine clean. At the end of each day, clean the machine. Wood contains moisture and
if sawdust or wood chips are not removed, it will cause rust. We recommend only using Teflon-
based lubricant on the saw. Regular oil attracts dust and dirt. Teflon lubricant tends to dry and
has less of a tendency to accumulate dirt and saw dust.
Periodically check that all nuts and bolts are tight.
12.2 Drive Belt & Bearings
Drive Belt: The drive belt should last for many years (depending on the usage). Regularly inspect
the belt for cracks, cuts, and general wear. Replace the belt if damage is found.
Bearings: All bearings are sealed for life and do not require any maintenance. Replace a bearing
if it becomes faulty.
12.3 As Needed
• Clean Engraving Table (work surface)
• Clean Mirror Surfaces (only if dirty)
• Clean Focal Lens (only if dirty)
• Check mirror alignment
• Replace laser tube